HT Holden

H Series Home

HT Holden specifications

HT Monaro specifications

HT Holden part numbers

10 facts you may not have known

HT Holden common issues

HT Holden paint codes

HK, HT & HG Holden Buyers Guide: What to Look for When Buying

When the Holden HT was released – Australia in 1969

HT Holden vs HK Holden

Australian Holden Part Finder

VT Commodore VT Olympic Edition

1999–2000 · Sedan
These are the parts we have for this exact vehicle. Not your vehicle? Change it

Some links below are affiliate links. If you buy through them we may earn a commission at no extra cost to you.

Your vehicle: VT Commodore VT Olympic Edition Change
Years 1999–2000
Body Sedan
Doors 4
Seats 5

← All categories

Oils

Affiliate link: if you buy through it we may earn a commission, at no extra cost to you.

Type Viscosity Capacity Specification Brand Notes Where to Buy
Automatic Transmission Oil
Fits 45 vehicles
View all compatible vehicles
Think this fitment is incorrect? Report it

Vehicle: VT Commodore VT Olympic Edition    Part: Automatic Transmission Oil

Dexron III (ATF) ~9.0-9.5 L (dry fill) 4-speed 4L60-E automatic Castrol Transmax Dexron III / Penrite Dex III Consistent with the 4L60-family automatic carried over from VR/VS.
Automatic Transmission Oil
Fits 59 vehicles
View all compatible vehicles
Think this fitment is incorrect? Report it

Vehicle: VT Commodore VT Olympic Edition    Part: Automatic Transmission Oil

Dexron III (ATF) ~9.0-9.5 L (dry fill) 4-speed 4L60 automatic (V8 Group A used ZF automatic in some variants) Castrol Transmax Dexron III / Penrite Dex III Dexron III is the standard recommendation for GM 4L60-family automatics of this era.
Differential Oil
Fits 67 vehicles
View all compatible vehicles
Think this fitment is incorrect? Report it

Vehicle: VT Commodore VT Olympic Edition    Part: Differential Oil

SAE 80W-90 GL-5 ~1.2-1.4 L Independent rear suspension (IRS) diff, open or optional limited-slip. Penrite Pro Gear 85W-90 GL-5 (+ LSD friction modifier if fitted) Capacity is a typical estimate, broadly consistent with VN-VS.
Differential Oil
Fits 67 vehicles
View all compatible vehicles
Think this fitment is incorrect? Report it

Vehicle: VT Commodore VT Olympic Edition    Part: Differential Oil

SAE 80W-90 GL-5 ~1.2-1.4 L Independent rear suspension (IRS) diff, smaller than the earlier live-axle Salisbury unit open or optional limited-slip. Penrite Pro Gear 85W-90 GL-5 (+ LSD friction modifier if fitted) As per VN/VP.
Engine Oil (V6: 3.8L Ecotec L36)
Fits 37 vehicles
View all compatible vehicles
Think this fitment is incorrect? Report it

Vehicle: VT Commodore VT Olympic Edition    Part: Engine Oil (V6: 3.8L Ecotec L36)

SAE 10W-30 5.3 L 3.8L Ecotec-generation pushrod V6 Castrol GTX 10W-30 / Penrite Everyday 10W-40 5.3L figure sourced from a CarsGuide Q&A on a 1998-era V6 Commodore. Holden\'s factory handbook spec for this era was 10W-30 do not use 20W-50, which is too heavy for this engine\'s oil-pump clearances. VZ also introduced the Alloytec 3.6L V6 late in its run alongside the outgoing Ecotec 3.8L — see VE/VF entry for Alloytec-specific figures if fitted.
Browse by make/series

The HT replaced the HK in 1969. Models progressively got swapped over starting with the Belmont, Kingswood and Premier model range in May 1969. June 1969 would see the Brougham and Monaro variants introduced to the Australian buying public.

It would represent a minor cosmetic facelift to the HK Holden that it replaced with a revised grille and tail lights. Many cannot tell the difference visually between the HK and the HT.

Mechanically, the 2 6 cylinder engine options remained. The 161 and the 186 ‘Red’ engine. The V8 engine line up would change however. The now iconic range of Australian V8’s, the 253 cubic inch and the 308 cubic inch V8, would first be seen in the HT. They replaced the imported 307 cubic inch unit. The 327 cubic inch imported V8 would be replaced by another American import, the 350 cubic inch Chevrolet V8.

HK HT HG Repair Manual

The HT also came with revised suspension and synchromesh on all forward gears on manual transmissions. Transmissions available were a 3 speed manual, a 4 speed manual and a 2 speed ‘Powerglide’ automatic. This would give drivers of the HT a smoother, more comfortable drive when compared to the HK.

Right Now on eBay HT Holden
Loading…

After a production run of 183 402 cars, the HT would be replaced 14 months later, by the HG in July 1970.

It would be known as the first Holden to be available with an Australian built V8. The now iconic 308 and 253 are still popular today.

H Series Home

HT Holden specifications

HT Monaro specifications

HT Holden part numbers

10 facts you may not have known

HT Holden common issues

HT Holden paint codes

HK, HT & HG Holden Buyers Guide: What to Look for When Buying

When the Holden HT was released – Australia in 1969

HT Holden vs HK Holden